Rate Limit



SCCM 2012 Low Bandwidth WAN

In my test lab I have started to test  SCCM 2012 over a low bandwidth (512k Down/256k UP) WAN (using my home brewed WAN emulator) our international offices. I have placed a Distribution point at each location and am deploying updates from our main site through the DP. I have set the Primary site to only use 10% of bandwidth during business hours and 100% after business hours. Of course I have set a separate boundary group for each site based on the AD sites and IP address.

Things I found so far:

This website and its content is copyright of ITHierarchy Inc - © ITHierarchy Inc 2013-2015. All rights reserved.

Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

  • you may print or download to a local hard disk extracts for your personal and non-commercial use only
  • you may copy the content to individual third parties for their personal use, but only if you acknowledge the website as the source of the material

You may not, except with our express written permission, distribute or commercially exploit the content. Nor may you transmit it or store it in any other website or other form of electronic retrieval system.


Subscribe to RSS - Rate Limit