SCCM 2012 R2 OSDFailed to get client identity 80004005

 

 

Submitted by Justin on Thu, 08/28/2014 - 10:28

So I was trying to image a computer using PXE. the computer booted into PE but would reboot after loading the network. I rebooted into PXE, hit F8 (you have to have this enabled on your boot image)

IPConfig showed network was properly configured

DiskPart showed I had a drive.

looked in the smsts.log file and I had the error: Failed to get client identity 80004005

everything looks right and it should work. I deleted all unknown computers from the console. rebooted and the same thing.

Next I checked the time by typing TIME. Time was correct.

Checked the date by typing DATE. Date was off. set the proper date, rebooted and long behold it worked...

Make sure your time and date are proper.

Tags: 
SCCM OSD
Failed to get client identity 80004005
SCCM PXE
SCCM 2012

This website and its content is copyright of ITHierarchy Inc - © ITHierarchy Inc 2013-2015. All rights reserved.

Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

  • you may print or download to a local hard disk extracts for your personal and non-commercial use only
  • you may copy the content to individual third parties for their personal use, but only if you acknowledge the website as the source of the material

You may not, except with our express written permission, distribute or commercially exploit the content. Nor may you transmit it or store it in any other website or other form of electronic retrieval system.

 

;